v1.23.2

Fillets that fit and finish cleanly

More rounds keep their shape at short faces and flat ends. Clearer size suggestions and complete shaded edges make the result easier to check.

Before & after

Rounded corners meet without gaps

Fillet junction lines stop before reaching the flat top face.Fillet junction lines connect completely to the flat top face.BeforeAfter
The same rounded block and camera in Shaded with edges. Fillet junctions now continue to the flat top face.Drag to compare · arrow keys work too
Before & after

Full rounds at flat ends

Authored curved lip before correction: the end section narrows.Authored curved lip after correction: the fillet retains its full section.BeforeAfter
The same authored curved-lip example and camera before and after the correction.Drag to compare · arrow keys work too
Before & after

Understand the suggested size

Recovery card shows a reduced preview alongside a larger suggested size without explaining the difference.Recovery card explains that the current request was reduced and the different suggested radius was checked at full size.BeforeAfter
The recovery section on the same authored short-wall example distinguishes the reduced preview from the separately checked alternative.Drag to compare · arrow keys work too

Everything in this release

Fixed

  • Fixed fillet junction lines that stopped before reaching neighboring flat faces in Shaded with edges.
  • Curved model edges stay steady as you orbit, while edges behind the model remain hidden.
  • Corrected fillets that narrowed at flat end faces or shrank unnecessarily after an earlier round.
  • Fillet and chamfer cards explain when the current preview was reduced and a different size was checked at its full size.
  • A reduced preview no longer appears beside a message saying that no smaller size worked; the card explains when no fully checked alternative was found.
  • Some fillets that were made smaller near an angled end now build at the requested radius, trimming the neighbouring face where needed.

Other improvements

  • Fillet and chamfer cards now distinguish a reduced preview from a separately checked smaller size, without contradictory failure messages.
  • Supported fillets that extend past a short face can now keep their requested radius when they meet an angled end.
  • Fixed curved-edge fillets that tapered at flat ends or shrank unnecessarily beside an earlier round.
  • Fixed incomplete fillet junctions and short breaks in curved model edges as you orbit in Shaded with edges.
Your projects